To transfer your pictures and video files wirelessly to your WiDRIVE 1, you need to complete the following steps.

(The BLUE procedure will only need to be completed one time since the settings are saved for future use.)


On your Xcorder:

a. Select «Setup», «General» and set WiDRIVE to «ON». Press «OK».


a Power up the WiDRIVE 1 (takes approximately 20 seconds)
b Make sure that the WiDRIVE 1 USB cable is not connected to the pc.
c Select sync from main menu of the Xcorder.

d Select WiDRIVE 1.
e Select sync.


When the sync operation is complete, plug the WiDRIVE 1 USB cable into your pc, and the transferred files will appear under the folder named Public.


Here is the same procedure showed in a video:


Important to know about WiDRIVE 1 syncing:

  • The Xcorder will not be able to sync to the WiDRIVE 1 when a USB cable is connected between the PC and WiDRIVE 1.
  • We recommend that the Xcorder is within line of sight of the WiDRIVE 1 when syncing.
  • Remember to catalog the files located in the WiDRIVE 1 folder after each sync. This is because the sync process will potentially overwrite files from the previous transfers if these files share the same filename.
  • If you are transferring large video files, or a large quantity of picture files, the transfer can take several minutes. Please be patient.